A-A-51206
Fatigue in cutting.
Side of head. Test shall be made on a milling machine or similar device. The feed shall be that produced by a 1-pound weight operating a cord attached to a carriage mounted on ball bearings. The bur shall rotate at 1,600 revolutions per minute. The material to be cut shall be 0.020 rolled brass with a Brinell hardness of 74-81 (Rockwell 30-T, 42-49). The edge of the brass shall be centered on the length of the head of the bur. The bur shall be perpendicular to the brass sheet, and the cut shall be made the length of the brass. A recording device operated by a synchronous motor shall be used to time the cut.
Tip of head. Test shall be conducted as in size of head, except that brass test piece shall be applied against the point of the bur.
Contractor certification. The contractor shall certify that the product offered meets the salient characteristics of this description and conforms to the producers’ own drawings, specifications, standards, and quality assurance practices. The Government reserves the right to require proof of such conformance prior to first delivery and thereafter as may be otherwise provided for under the provisions of the contract.
Regulatory requirements.
Federal Food, Drug and Cosmetic Act. If the product covered by this document has been determined by the U.S. Food and Drug Administration to be under its jurisdiction, the offeror/contractor shall comply, and be responsible for compliance by its subcontractors/suppliers, with the requirements of the Federal Food, Drug and Cosmetic Act, as amended, and regulations promulgated thereunder. In addition, the offeror/contractor shall comply, and be responsible for compliance by its subcontractors/suppliers, with the requirements of all other applicable Federal, State, and local statutes, ordinances, and regulations.
Recovered materials. The offeror/contractor is encouraged to use recovered material in accordance with Public Law 94-580 to the maximum extent practical.
Preservation, packaging, packing, labeling, and marking. Unless otherwise specified, preservation, packaging, and packing shall be to a degree of protection to preclude damage to containers and/or contents thereof under normal shipping conditions, handling, etc., involving shipment from the supply source to the receiving activity, plus reshipment from receiving activity, and shall conform to applicable carrier’s rules and regulations. Intermediate and exterior package quantities and labeling and marking shall be as specified in the contract and/or order.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business