A-A-54464
in both open and closed positions. The rongeurs shall be free of excessive stiffness and shall not have excessive play when the rongeur is in the open or closed position.
Finish. The rongeurs shall have a bright finish, except the handles shall have a satin finish, and the concave surfaces of the beak shall have a finely honed surface.
Corrosion resistance. Corrosion resistance tests shall be in accordance with ASTM Designation F1089. The copper sulfate and boil tests shall apply to the entire rongeur.
Identification marking. Each rongeur shall be marked with the applicable instrument number. Each rongeur shall be marked with the country of origin, the name or registered trademark of the manufacturer (and contractor, if other than the manufacturer) and the word “stainless”. All markings shall be permanent and legible.
Workmanship. Each rongeur shall be free from burrs, cracks, scratches, sharp edges and pits defects which detract from its appearance or impair its serviceability.
Unit. Each (EA). One rongeur of the design number, specified, constitutes one unit.
Quality Assurance Provisions.
Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contact or purchase order, the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
Records. Records of examinations and tests performed by or for the contractor shall be maintained by the contractor and made available to the Government upon the Government’s request, at any time, or from time to time, during the performance of the contract and for a period of three years after delivery of the supplies to which such records relate.
Inspection. Inspection, as used herein, is defined as both examination (such as visual or auditory investigation without the use of special laboratory appliances or procedures) and testing
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business