A-A-51563
The arbor and band set shall consist of the following assortment:
Six arbors.
Six screws.
Six washers.
Three sleeves, 1/4 inch O.D.
Three sleeves, 3/8 inch O.D.
One hundred abrasive bands, 60 grit, 1/4 inch I.D.
One hundred abrasive bands, 60 grit, 3/8 inch I.D.
One hundred abrasive bands, 80 grit, 1/4 inch I.D.
One hundred abrasive bands, 80 grit, 3/8 inch I.D.
Workmanship. The arbor and band set shall be free from defects which detract from its appearance or may impair its serviceability. The arbors, with sleeve and band attached, shall run true. The accessories shall interface with each other properly to provide a uniform ground surface on the devices being prepared. The sleeves shall be properly glued, to prevent raveling. The abrasive coating shall be of uniform thickness.
Unit. Set (SE). One arbor and band set, as specified, constitutes one unit.
Quality Assurance Provisions.
Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contact or purchase order, the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
Records. Records of examinations and tests performed by or for the contractor shall be maintained by the contractor and made available to the Government upon the Government’s request, at any time, or from time to time, during the performance of the contract and for a period of three years after delivery of the supplies to which such records relate.
Inspection. Inspection, as used herein, is defined as both examination (such as visual or auditory investigation without the use of special laboratory appliances or procedures) and testing (determination by technical means of physical and chemical properties) of the item.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business