A-A-51005
30 August 1985
COMMERCIAL ITEM DESCRIPTION
STAND, DISK, DENTAL
The General Services Administration has authorized the use of this commercial item description.
This commercial item description covers a disk stand to hold assorted disks.
Salient characteristics:
The disk spindle stands shall be suitable for holding assorted square brass center disks or pin hole type disks, up to 7/8 inch (22.2 mm) in diameter. The base shall be 5-3/4 ± 1/10 inches (14.0 cm) long; 2-1/2 ± 1/32 inches (6.4 cm) wide; and a minimum of 7/32 inch (5.6 mm) thick. Shall have two rows of six spindles at least 15/16 inch (2.4 cm) apart in both horizontal directions, so as to accommodate disks of 7/8 inch (22.2 mm) in diameter, without interference. The spindle shall be press fitted into the base and the tops shall be rounded to prevent injury to the fingers of the user. The spindles shall be 0.002 ± .002 inch (1.6 mm) in diameter and have an exposed length of 2 ± 1/32 inch (5.1 cm). The stand shall have a clear, one-piece, plastic cover which shall fit snugly onto the base. Twelve washer-type retainers shall be furnished to keep disks on the spindles.
Material. The base shall be made of rigid plastic. The cover shall be made of clear plastic. The spindles shall be made of corrosion-resisting steel or plated alloy steel. The disk retainers shall be made of elastomeric materials.
Workmanship. The disk stand shall be free from defects which detract from its appearance or impair its serviceability.
Unit. Each (EA). One disk stand, as specified, constitutes one unit.
Quality Assurance Provisions.
Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise specified in the contract or purchase order, the contractor may use his own or any facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business